LSRC TF2 82 Pickup / Marlin Body Mounts

LSRC TF2 82 Pickup / Marlin Body MountsFresh Release! These body mounts offer a whole new system to the crawler scene with provisions for bolt on rock sliders that can be swapped from one body to the next on multiple platforms that also utilize our body mounts. The versatility doesn't stop there either; these were designed to have optimal clearance in mind for those long leaf setups, allowing those front shackles to lay all the way back into the frame without interference. the trailing

Fresh Release!

These body mounts offer a whole new system to the crawler scene with provisions for bolt on rock sliders that can be swapped from one body to the next on multiple platforms that also utilize our body mounts.

The versatility doesn't stop there either; these were designed to have optimal clearance in mind for those long leaf setups, allowing those front shackles to lay all the way back into the frame without interference. the trailing edge of each of these body mounts allows room for multiple styles of rear axle leaf spring hardmounts such as TwistedFabCo or our own, to include our bed mounting kits for RockSlugCustoms printed beds.

Each set of body mounts are fitted with brass heat inserts for your body screws for lasting positive engagement and unparalleled strength, while the printed material is engineered to give enough flex when/where needed and will withstand the elements.

Our RWB TF2 Body Mounts add one extra provision over our LWB body mounts... an extra "hidden" brass heat insert on the frame side for securing the front bolt hole on our "Hidden Servo Winch Mount" for use on either frame rail on the inside when paired with our TF2 RWB Multi-Trans Flat Skid.

Choose between two different types specific to your setup. Cab ONLY are shorter overall and will tuck inside of the body with a full Cab Back. "With Bed" features a notch in the rear section of the mount to provide clearance for the lower bed screws.

If you've struggled in the past with tire clearance, these are your solution. Our TF2 Body mounts provide a 5mm body lift over stock, retaining the same lateral positioning so that they remain compatible with the hottest leaf spring parts on the market, no longer requiring fender trimming, tested on tire sizes up to 4.65 diameter.

Each pair of body mounts includes a set of screw backers to be used when bottom mount skid plates are used. Skids such as those made by BowhouseRC, RSC and Our NEW printed TF2 Multi-Trans Flat Skids (shown pictured) will replace those screw backers and provide the securement needed.

**NOTE** Cab ONLY variant is 5mm wider each side for precise fitment with the factory cab back installed