3" IPS HDPE 3408/4710 SDR 11 90 Sweep

3" IPS HDPE 3408/4710 SDR 11 90 SweepThe 3" IPS HDPE SDR11 Poly Cam 90 Degree Sweep is manufactured from High Density Polyethylene (HDPE) pipe. It is designed with a butt fusion end for ease of field installation. The design allows fluid to travel through the fitting with less restriction. These have an angular tolerance of + 4 Degrees High Density Polyethylene HDPE pipe Meets ASTM D 3350 with minimum cell classification values of 345464C (PE 3408), PE445574C (PE 4710) Meets ASTM F714.

The 3" IPS HDPE SDR11 Poly-Cam 90 Degree Sweep is manufactured from High Density Polyethylene (HDPE) pipe. It is designed with a butt fusion end for ease of field installation. The design allows fluid to travel through the fitting with less restriction.   These have an angular tolerance of +/- 4 Degrees

High-Density Polyethylene HDPE pipe

• Meets ASTM D-3350 with minimum cell classification values of 345464C (PE 3408), PE445574C (PE 4710)
• Meets ASTM F714.
• Density shall be no less than 0.955 g/cm as referenced in ASTM D1505
• Melt index no greater than 0.15 g/10 minutes when tested per ASTM D 1238
• Tensile Strength at Yield –tensile shall be 3,200 psi to less than 3,500 psi as referenced in ASTM D638
• ESCR-Environmental Stress Crack Resistance shall be over 5,000 hours with zero failures when tested per ASTM D 1693-Condition C
• All pipe meets ASTM 3035.

Dim A: 3.5"
Dim B: 7"
Dim C: 17.5"
Dim R: 10.5"